Cotol - 240

Cotol-240™ Cleaner & Cure Acceleratoris a urethane cure accelerator and pre-cleaner to be used in conjunction with Aquaseal® or Aquasure™. The solvent cleans and prepares the surface, readying it for Aquaseal® or Aquasure®, speeding the tack time to 15 minutes and the full cure time to less than two hours. Cotol-240 is also ideal for removing tar, sap, glue, and other resins from various surfaces including glass, plastic and metal.Available in 1/2 oz. Blister Pack, 4 oz. and Quart (not shown).

Cotol-240™ Directions for use with Aquaseal® or Aquasure™ Urethane Repair Adhesive and Sealant:

AS PRECLEANER:

1. Apply a small amount to the damaged area (spot test for colorfastness).
2. Rub with a clean cloth until dry.
3. Repeat steps 1 and 2.
4. Apply Aquaseal as directed.
   Note: for best adhesion, first roughen non-fabric surfaces with sandpaper.

AS CURE ACCELERATOR:

1. Thoroughly mix 1 part cure accelerator with 3-4 parts Aquaseal® or Aquasure™ using a stick, toothpick, or knife. Mix on a non-absorbent surface such as a plastic lid or plate.
2. Immediately apply the mixture to the damaged area.
3. Allow the repair to completely cure at least 2 hours before using.

FOR COLORS: Mix food coloring or paint colorant (available at paint stores) into the Aquasure and cure accelerator before applying.

CLEAN-UP: To remove Aquaseal? or Aquasure? from hands, use cloth soaked with paint thinner, nail polish remover or 99% isopropyl alcohol.

STORAGE: Cap tightly. Store in cool, dry place. Use blister card package for storage.